Assessment of the screw
extruder architecture & design.
o one unit of 1T/h or more mulitplied by x embedded unit to reach an expected throughput of 15T/h (why 15T/h ?)
o independent trailer with densification module and engine (heat exchanger,..)
- reason of the choice : screw extruder vs. hydraulic press
o more flexibility to implement variable parameters : diameter, compression rate, format (briquette, half or quarter briquette, pellets depending the particle size), maintenance
o model (designed by 2ZK’s partner):
- questionnaire :
o features of one unit maintenance : wearing part of the screw (sand and silicate)
o mechanical power: hydraulic reductor, possible replacement by electrical motors (later hybrid version)
- features and dimensions, embedded densification capacity of one unit on one trailer (dimension, weight, vibration,..).
- Mechanical power : embedded diesel engine , 50kW/T x15T/h > +/- 1x 600kW or 2x300kW (MTU, Volvo ?)
- Design of one model, scale model ( ?)
This service is a commercial detection missions.
the offers below are exclusively dedicated to freelance experts who are in a position to bill their services to contractors. These are not job offers.
If the mission is shown here is that it is in principle still valid
For your security we check that the mission is still valid before charging your credit card or cashing your check.
The contact details of the contractor are sold to a very limited number of experts (2 or 3).